Zdrowie i bezpieczeństwo, użytkowanie i pielęgnacja, instrukcja instalacji oraz informacje o rejestracji gwarancji online Haier D 210g

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

I live in an area where I have about 12" of hardpan about 12" down so it was a difficult

Thank you for one of the best tool rip-downs and reassemblies I have ever seen. You have taught me.

Great video I do videos myself on YouTube and have done one on the DCH253 model. It was nice to see a DCH273 taken apart.Really well done liked and subscribed

Thanks for this, I couldn't have fitted a new motor and trigger assembly without you. Great video.

This was a great teardown and reassembly of this classic DeWalt drill. Please do a similar video of the DeWalt DCD640 (joist & stud drill). Again one of the best videos I have seen

There are two significant additions I would add to this. If you are reassembling the gear box put it in hammer mode and then make sure the pin on the little toggle which is at the back of the drill/hammer switch is correctly seated through the hole and fits correctly when you put on the gear box cover. The second thing is if you do remove the hammer cylinder etc you must put the ball socket through the crankshaft with the three holes in it first (at and angle) and then put the pin back through the hole at back of cylinder. It goes behind a little nib on the crankshaft. Otherwise the pin keeps coming out of the hole and your hammer action either gets stuck or does not work. Failure to do these two things gives you a drill with no hammer action and also a gear box which you will struggle to close correctly.

spent forever trying to figure out where that little spring went cause it shot out when I popped the case. You were super helpful!

Legend. Thanks for the video. Mine just died the other day. It's old. But may just try your advice! Thanks

Merci Grace à votre vidéo j’ai pu réparer

Great video. all the little mistakes you were making I was making them too so it helped a lot lol The only problem I have is my hammer action hasn’t worked since the tare down. Any tips on this

The hammer function in my tool stopped working recently. I put the tool through hell digging out my basement through countless hours of rock & dirt. I have been thinking about trying to take it apart & after your video I feel I can do it. Thanks for sharing!

Thank you! My drills problem was bad solder connections where the wires terminate at the motor.

Nice work- I have a dch273 also that suddenly stop working what could be the problem with it?

Mahalo for the vid, helped me with the issues that I had

I just repaired mine thanks to you video. The "hammer" cylinder was stuck, i had to sand it down

Brooo you the man. I fix mines!

Thanks mate you are the best

i think the spring on the head should be installed different side

My Dewalt dch273 keeps running slow on drill mode , do you think I can get away with cleaning it up inside or will I have to replace clutch/gearbox?

Hi , I opened my sds and one pin with the ball came and im not sure where it came from that’s the inly thing I couldn’t see in tour nice and helpful video , can you please let me know thanks

.

Zostaw komentarz

#0